State Industries Water Heater SMGSS01207 User Manual

R E S I D E N T I A L

MANUFACTURED

HOUSING

Standard-Vent and Direct-Vent Gas Water Heaters

™

SELECT

Complies with HUD Standards for Manufactured Housing

Installation. Design-Certiﬁed by CSA International -

Also complies with National Appliance Energy Conservation Act (NAECA)

energy-efﬁciency standards effective January 20, 2004.

Gas Control Is Convertible for Natural and Propane Gas -

For ﬂexibility to meet the varying needs of Manufactured Housing installations.

Side-Mounted 3/4” Cold Water Inlet - For ease of installation

when cold water supply originates below the structure. Top-mounted 3/4" hot water outlet.

Direct-Vent Models Packaged with Bottom Intake Air Vent -

To draw all combustion make-up air from outside the structure.

Optional Ducted Air Inlet Kit for Direct-Vent Models - For use when

water heater is installed over a basement. Provision for horizontal air inlet ducting up

to 30 feet, using Schedule 40 PVC pipe. Kit includes 45° rodent-proof termination

cap and wall collars. Kit #9002986 for 30 and 40 gallon models. Kit #9002987 for

50-gallon models.

Approved Roof Jack Kits Required for Installation of

Direct-Vent Models -

Four kits available to accommodate vertical vent distances from 12" to 96"

(see back of sheet).

Green Choice™ Eco-Friendly Gas Burner - Patented design reduces NOx

emissions by up to 33% and complies with Southern California and Texas requirements.

Glass-Lined Tank - For long-lasting protection against rust and corrosion.

Anode Rod - Helps protect against rust and corrosion for long life.

Factory-Installed Temperature & Pressure (T&P) Relief Valve

Maximum Hydrostatic Working Pressure 150 PSI

6-Year Tank and 2-Year Limited Parts Warranty

For more information on State® contact:

State Water Heaters

500 Tennessee Waltz Parkway, Ashland City, TN 37015

800-365-0024 Toll-free

SMGSS01207

August 2007R