Soleus Air Electric Heater HGW 308 User Manual

FLAT PANEL MICATHERMIC HEATER  
FLAT PANEL  
MICATHERMIC  
HEATER  
Micathermic is a new method of heating that utilizes technology from both convection  
and reflective heat. The heater releases 80% reflective and 20% convection heat,  
distributing heat consistently and more evenly throughout the room. The heater releases  
healthy infrared heat, directly warming surrounding objects. As the surrounding objects  
absorb heat, the air temperature rises.  
USER MANUAL  
Model # HGW-308  
Nowadays, saving energy is very important. Our heater features an ECO function  
specifically designed for this reason. When the room temperature reaches the desired  
temperature, one-third of energy will be cut-off automatically.  
Special Features  
¾
¾
¾
¾
¾
¾
¾
¾
¾
¾
¾
Safe and healthy  
Heats instantly and silently  
Economic energy saving function [ECO]  
Adjustable thermostat  
Power and temperature control light indicator  
Anti-freeze setting  
Overheat safety protection  
Lightweight  
Quiet  
Non-flammable surface  
No dehumidifying  
Specifications  
Voltage Rating  
Power Consumption  
Unit Size  
115 V, 60Hz  
1500W  
8.5“(L)x 22.5”(H)x 24.75“(W)  
11.5 lbs  
Unit Weight  
PLEASE SAVE THESE INSTRUCTIONS  
 
Installation  
Operation  
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER !  
Required tools for use on floor:  
phillips screwdriver  
(not included)  
1. Ensure that the Temperature  
Control Knob is at “DOT”  
position. [Fig 1]  
Required tools for wall  
mounting:  
phillips screwdriver  
(not included)  
drill (not included)  
hammer (not included)  
Also, make sure the power  
switch is at the off position.  
[Fig 2]  
A. On the floor  
Insert the feet and bolts onto the  
unit as shown in the diagram.  
2. Plug the power cord into a  
suitable electrical outlet.  
[Rated not less than 115 volt]  
B. On the wall  
3. Turn the power switch to the  
“ON” position, then adjust the  
Temperature Control Knob  
clockwise until the Red Light  
Indicator turns on [Fig 2]. At this  
moment, the Temperature  
STEP 1  
Using the mounting support as a  
guide, mark the first screw hole  
on the wall.  
Control will start working.  
STEP 2  
Drill first hole.  
Note: The Red Light Indicator  
will turn off when the room  
reaches the desired temperature.  
After a while, as the room  
temperature falls, the heater will  
turn on again and release heat  
until the room temperature rises  
to the desired temperature.  
Desired room temperature is  
maintained automatically by this  
procedure.  
STEP 3  
Insert first screw anchor into the  
first hole.  
STEP 4  
Put mounting support on the wall  
and tighten it lightly.  
STEP 5  
Mark second screw hole on the  
wall [approximately 5 7/16 in.].  
STEP 6  
Drill second hole.  
You can adjust the temperature  
control knob to increase or  
STEP 7  
decrease the room temperature as  
desired by turning in a clockwise  
or counter-clockwise direction as  
shown in the figure.  
Insert second screw anchor into  
the second hole.  
STEP 8  
Tighten both screws.  
 
Important Safeguards  
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER !  
4. To obtain a desirable  
temperature, there is an area  
indicated on the Temperature  
Control Knob known as the  
“Comfortable Zone.” You can  
adjust the knob to select a  
temperature within this range.  
¾
The heater is hot when in use. To avoid burns, do not let bare skin touch hot  
surface. Use handles when moving this heater.  
Keep combustible materials, such as drapery and other furnishings, at least 3  
feet [0.9m] from the front of the heater and away from the sides and rear.  
Extreme caution is necessary when any heater is used by or near children or  
invalids, or when the heater is left operating or unattended.  
Do not use outdoor. Never locate heater where it may fall into a bathtub or  
other water container.  
This heater has hot and arcing or sparking parts inside. Do not use in areas  
where gasoline, paint or flammable liquids are used or stored.  
Do not insert or allow foreign objects to enter any ventilation or exhaust  
opening as this may cause an electric shock or fire, or damage the heater.  
To prevent a possible fire, do not block air intakes or exhaust in any manner.  
Do not operate this appliance on soft surfaces because the inlet openings can be  
blocked.  
Always unplug heater when not in use. To disconnect heater, turn controls to  
off, then remove plug from outlet.  
Avoid using an extension cord because the extension cord may overheat and  
cause a risk of fire. However, if an extension cord must be used, the conductor  
wire inside the cord must be No.14 AWG minimum size and rated not less than  
1875 watts.  
¾
¾
¾
¾
¾
5. Anti-Freeze Setting  
This setting keeps the  
temperature of the surrounding  
area above freezing to prevent  
pipes from breaking. To do this,  
simply plug in the heater and  
turn the Temperature Control  
Knob to the “Snowflake”  
position. The heater will  
automatically turn on when the  
ambient temperature drops  
below 41°F.  
¾
¾
6. Economic Energy Saving  
Function (ECO)  
When the room temperature  
reaches a certain point, the ECO  
Green Light will switch on,  
indicating that one-third of the  
power has been cut-off  
¾
Do not run cord under carpet and do not cover cord with throw rugs, runners,  
or the like. Place the cord away from traffic area and where it will not be  
tripped over.  
¾
¾
The heater must not be located immediately below an outlet.  
Do not operate any heater with a damaged cord or plug, after the heater  
malfunctions, or has been dropped or damaged in any manner. If the heater is  
damaged, it must be serviced by the manufacturer or a similarly qualified  
service agent in order to ensure safety.  
automatically to save energy.  
[ our 1500 Watt heater will work  
on 1000 Watts]  
¾
¾
Connect the heater to properly grounded outlets only.  
Use this heater only as described in this manual. Any other use not  
recommended by the manufacturer may cause fire, electric shock, or injury to  
persons.  
Do not use this heater with a programmer, timer or any other device that  
switches the heater on automatically, since a fire risk exists if the heater is  
covered or positioned incorrectly.  
7. Overheat Safety Protection  
The heater comes equipped with  
overheat safety protection, so it  
can detect if it is overheating and  
will automatically shut off.  
When the unit temperature falls  
again, power will be resumed.  
To avoid overheating and  
potential risk of fire, DO NOT  
cover the heater.  
 
Cleaning  
WARRANTY  
¾
¾
¾
¾
¾
Before cleaning, turn off the heater, unplug the power cord and allow the  
heater to cool.  
Do not immerse power cord and plug or heater in water or other liquid or pour  
water or other liquid over the heater.  
Use a vacuum cleaner to remove dust and lint from the metal grille of the  
heater.  
Wipe the heater with a dry cloth to remove dust and a damp cloth [not wet] to  
clean off stains.  
Do not use detergents, abrasive cleaning powder or polish of any kind on the  
body of the heater, as these can damage the finish.  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air HGW-308 to be free of defects in  
material and workmanship for the applications specified in its operation instruction for a period of  
ONE (1) year from the date of original retail purchase in the United States or Canada.  
If the heater exhibits a defect in normal use, Soleus International Inc. will, at its option, either  
repair or replace it, free of charge within a reasonable time after the heater is returned during the  
warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty  
Certificate along with a copy of the original purchase invoice.  
Storage  
THIS WARRANTY DOES NOT COVER:  
¾
Store the heater in a cool dry location. Preferably, to prevent dust and dirt build  
up, use the old packaging to repack the unit.  
1) Damage, accidental or otherwise, to the heater while in the possession of a consumer not  
caused by a defect in material or workmanship.  
2) Damage caused by consumer misuse, tampering, or failure to follow the care and special  
handling provisions in the instructions.  
3) Damage to the finish of the case, or other appearance parts caused by wear.  
4) Damage caused by repairs or alterations of the heater by anyone other than those authorized  
by Soleus International Inc.  
Troubleshooting  
HEATER WILL NOT HEAT  
5) Freight and Insurance cost for the warranty service.  
1. Check if the heater is plugged in and turned on.  
2. Check if the Temperature Control Knob is in the right position.  
3. Check if any objects are covering the unit.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY  
ARE LIMITED TO ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY.  
SOLEUS INTERNATIONAL INC. DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL  
OR INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS INTERNATIONAL  
INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE HEATER FOR BREACH OF  
ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS HEATER.  
HEATER WILL NOT TURN ON  
1. Check if the power cord is plugged into an electrical outlet.  
2. Check if electricity or the main fuse is working.  
3. Make sure the power switch is at [ON] position.  
4. Check if the heater is on the Thermostat Control condition [ensure the Light  
Indicator is on].  
As some states do not allow the limitation or exclusion of incidental or consequential damages, or  
do not allow limitation on implied warranties, the above limitations and exclusions may not apply  
to you. This warranty gives you specific legal rights, and you may also have other rights that vary  
from state to state.  
For Warranty, Technical Support, Customer Service, Missing or Defective Parts  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
9451 Telstar Ave.  
El Monte, CA 91731 USA  
 

Sennheiser Satellite Radio SK 500 G2 User Manual
Sharp Calculator EL 1197PIII User Manual
Sharp Microscope Magnifier DK KP82PH User Manual
Sony Computer Monitor CPD G400P User Manual
Spalding Fitness Equipment M8660411 User Manual
Spectra Stereo System AI111 User Manual
Stoelting Welder 51447 User Manual
Sunbeam Electric Heater HE4200 User Manual
SunBriteTV Car Stereo System DS 3214TSL User Manual
SVA Security Camera CRR 1103 User Manual